Refrigeration OPTIONS

How to operate CoolBox 12 Volt all-electric refrigeration

  • If fitted with Standby single phase, 16 Amp, 240 volt power option, locate the extension cable.

  • Note the power source selector and switch positions

  • To operate with vehicle engine running, turn switch to 'VEHICLE'

  • Start vehicle engine to avoid flat battery

  • To operate on standby power, turn switch to 'HOUSE'

  • Connect 16AMP single phase extension lead to wall socket

  • Switch power ON in House/Building

  • Connect extension lead to socket on vehicle. Note: Transformer fan will start inside vehicle

  • Both power sources will light the 'On/Off' button to red

  • Short Press On/Off button to start refrigeration. Beep will sound

  • 15-20 second delay while Compressor and Fans start. Current temperature will display on screen

  • Short press 'SET' button to cycle between SET and CURRENT temperatures

  • Fans will run and temperature will begin to drop

  • Always load PRE-CHILLED product for the best efficiency and keep DOORS CLOSED to avoid icing up the evaporator

  • Always leave gap above and space around products for suitable airflow

  • Keep floor and door seals clean. Note drains in floor for washing out CoolBox

  • Door locks are under flap

  • To adjust temperature, press SET to display set point.

  • Use UP & DOWN buttons to raise or lower temperature

  • Note upper and lower LIMITS have been pre-set

  • Press SET to enter temperature and return to Current temp display

  • To turn off, Long press On/Off button (3-5 seconds) or switch off engine. Last settings will be stored